ImagePro>control NI DAQ from macro

[IPUserGroup[at]aol.com]

Dear IPP Users:
Can you control a light source (0-5V input ) with a National Instruments DAQ 
(I/O card with analog voltage output) using the IPP macro language? The 
lighting can be controlled using the National Instruments NI-DAQ software 
(VBX).  Can an IPP macro call a dll written in VB with the NI-DAQ or is there 
any example macros on how to incorporate an I/O card into IPP?
Thanks you for your help.
Geoff

***********************************************************
Need an Image-Pro macro or driver? Find it at http://www.Solutions-Zone.com
Got an Image-Pro macro or driver? Add it to http://www.Solutions-Zone.com
***********************************************************

This message is sent to you because you are subscribed to <imagepro-users@lists.mediacy.com>.
To unsubscribe, email to: <imagepro-users-off@lists.mediacy.com>
To switch to the DIGEST mode, email to <imagepro-users-digest@lists.mediacy.com>
To switch to the INDEX mode, email to <imagepro-users-index@lists.mediacy.com>
Send administrative queries to  <imagepro-users-request@lists.mediacy.com>
To subscribe or unsubscribe visit http://www.solutions-zone.com/ipednld/subscriber.asp